lap joint

英 [læp dʒɔɪnt]

美 [læp dʒɔɪnt]

（互）搭接（头）；叠接；搭接接头；搭接缝; 搭接接头；搭接焊缝

计算机化学

英英释义

noun

• joint made by overlapping two ends and joining them together
  Synonym:splice

双语例句

• Study on Laser Welding for Lap Joint of Stainless Steel 'Case
  不锈钢机匣组件激光叠接焊工艺研究
• Most scholars mainly adopted one dimension variation analysis model, and took qualitative analysis on the butt joint, lap joint of the parts in the research field of assembly sequence optimization which targets was dimension quality.
  以装配尺寸质量为目标的装配顺序优化研究方面，多数学者主要采用一维的偏差分析模型，对零件间的对接、搭接等接头形式进行定性分析。
• The research is carried out with the method of orthogonal test to study the effects of some main parameters such as Poisson ratio, elastic modulus and adherend of thick on the peck value of the Von Mises equivalent stress distributed in adhesively bonded aluminium single lap joint.
  运用正交试验法研究了几个主要力学和几何参数如泊松比，弹性模量和被粘物厚对单搭接接头VONMISES等效应力的影响。
• The results indicate that good lap joint between aluminum and galvanized steel sheet can be made in appropriate parameters.
  试验结果表明，铝和镀锌钢能得到成形良好的搭接接头。
• The structure of intersecting Lap joint Between steel pipe has been widely applied in engineering project, such as Oil and gas pipelines, Pressure vessel and Various forms of pipe truss structure.
  工程中钢管与钢管的相贯搭接广泛的应用于油气管道、压力容器以及各种形式的管桁架钢结构中。
• Taking the form of lap joint as an example, the effect of final assembling deviation affect by the assembly sequence was analyzed by adopting the method of worse condition.
  以搭接接头形式为例，采用最坏情况法分析了装配顺序对最终装配偏差的影响。
• The orthogonal test of numerical modeling on the peck stress distributed in single lap joint
  单搭接接头峰值应力数值模拟的正交法分析
• Based on the principle and process of laser transmission welding, the lap joint form was taken and the key technology and difficulty of welding were also considered.
  基于激光透射焊接的原理和过程，采取搭接接头形式进行焊接，同时焊接关键技术和难点也被考虑。
• However, further increasing of RE content would degrade the shear properties of the lap joint.
  而当稀土含量进一步增加时，焊点的强度及塑性均下降。
• The elasto-plastic finite element method ( FEM) was used to investigate the effect of the elastic modulus of adhesive on the stress and strain distribution in adhesively bonded aluminium single lap joint.
  利用弹塑性有限元法研究胶粘剂的弹性模量对单搭接接头应力应变分布的影响。